dual-stack APN w/ 464XLAT

[jordi.palet at consulintel.es]

You should configure a single APN that allows v4, v6 and v4v6 PDP types.

That will work, done many times, last week tested in an operator in Tonga actually.

Note that testing with iOS is tricky unless you use the Configurator or work with the Apple liaison.

Regards,
Jordi

@jordipalet


> El 19 jun 2023, a las 16:43, Yannis Nikolopoulos <dez at otenet.gr> escribió:
> 
> Hi,
> 
> This is for mobile operators mainly. Let's assume that a single APN is available. Let's also assume that a small number of subscribers' devices do not support IPv6 at all. The idea is to deploy a kind of a dual-stack APN, where the device gets IPv4 if IPv6 is not supported and IPv6-only (464XLAT) if IPv6 is supported.
> 
> Does that make sense? Would it work?
> 
> Cheers


**********************************************
IPv4 is over
Are you ready for the new Internet ?
http://www.theipv6company.com
The IPv6 Company

This electronic message contains information which may be privileged or confidential. The information is intended to be for the exclusive use of the individual(s) named above and further non-explicilty authorized disclosure, copying, distribution or use of the contents of this information, even if partially, including attached files, is strictly prohibited and will be considered a criminal offense. If you are not the intended recipient be aware that any disclosure, copying, distribution or use of the contents of this information, even if partially, including attached files, is strictly prohibited, will be considered a criminal offense, so you must reply to the original sender to inform about this communication and delete it.