Prefix delegation to sub nets

[Doug Hardie]

-- Doug

> On 27 June 2021, at 12:41, Michael Chang <thenewme91 at gmail.com> wrote:
> 
> If you actually want that topology, I think in practice the downstream router (B) must be at least a /64; if you got a /48 then I think you can set up A with /56s, which it can use to sub-allocate a /64 to B.
>  
> https://tools.ietf.org/id/draft-ietf-homenet-arch-01.html <https://tools.ietf.org/id/draft-ietf-homenet-arch-01.html>
> 
> The config in section 7.2 of https://wiki.archlinux.org/title/IPv6#Prefix_delegation_(DHCPv6-PD) <https://wiki.archlinux.org/title/IPv6#Prefix_delegation_(DHCPv6-PD)> might be what you're looking for? (See the note about `sla-len`.)

The addresses could be done that way.  However, the issue still remains, how does router B distribute the prefix?  Is using a dual dhcp6c - dhcp6s the way to go and how does dhcp6s get the prefix from dhcp6c?

> 
> 
> On Sun, Jun 27, 2021 at 12:05 PM Kristian McColm <Kristian.McColm at rci.rogers.com <mailto:Kristian.McColm at rci.rogers.com>> wrote:
> RFC 5375 advises against prefixes longer than /64. 
> 
> https://datatracker.ietf.org/doc/html/rfc5375#appendix-B.2 <https://datatracker.ietf.org/doc/html/rfc5375#appendix-B.2>
> 
> A /48 gives you 65535 /64’s, why not use some of them?
> 
> From: ipv6-ops-bounces+kristian.mccolm=rci.rogers.com at lists.cluenet.de <mailto:rci.rogers.com at lists.cluenet.de> <ipv6-ops-bounces+kristian.mccolm=rci.rogers.com at lists.cluenet.de <mailto:rci.rogers.com at lists.cluenet.de>> on behalf of Doug Hardie <bc979 at lafn.org <mailto:bc979 at lafn.org>>
> Sent: Sunday, June 27, 2021 2:54:01 PM
> To: ipv6-ops at lists.cluenet.de <mailto:ipv6-ops at lists.cluenet.de> <ipv6-ops at lists.cluenet.de <mailto:ipv6-ops at lists.cluenet.de>>
> Subject: Prefix delegation to sub nets
>  
> I am trying to setup an IPv6 environment.  There is a primary router (A) that receives a /48 prefix via DHCP6 from the ISP. That router configures itself properly via dhcp6c.  It also creates 2 LAN /64 prefixes and creates EUI-64 addresses on the two LAN interfaces.  One of those interfaces is connected to a second router (B), among other devices.  The B router receives the prefix via SLAAC and creates its own EUI-64 address.  However, that router needs to create a smaller subnet, /72, and distribute it to the devices on that LAN.  I have not been able to figure out how to make that happen.
> 
> Clearly, manual configuration would work, but the prefix received from the ISP can change which would raise havoc with the network.  I suspect that dhcp6s needto be run alongside dhcp6c on router B and then the other devices run dhcp6c.  However, I don't see how to get the prefix that dhcp6c receives on router B to the dhcp6s process on router B.  I believe I am missing something, but haven't been able to find it.  Thanks,
> 
> -- Doug
> 
> 
> 
> 
> 
> This communication is confidential. We only send and receive email on the basis of the terms set out at www.rogers.com/web/content/emailnotice <http://www.rogers.com/web/content/emailnotice>
> 
> 
> 
> Ce message est confidentiel. Notre transmission et réception de courriels se fait strictement suivant les modalités énoncées dans l’avis publié à www.rogers.com/aviscourriel <http://www.rogers.com/aviscourriel>
> 
> 
> -- 
> Michael Chang

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.cluenet.de/pipermail/ipv6-ops/attachments/20210627/20059bc2/attachment.htm>